ok... so i pulled the blug underneath the bike... drained the oil.... opened up the filter case... drained the oil out and swapped the filter... my question is, how and where do i get the oil out of the tank from. i had to roll my raptor almost completely on its side to empty her out. i was looking for other places to unscrew to drain the oil but i couldnt figure it out... help?

There is a drain bolt on the bottom of the tank it almost looks like a mounting bolt but it is a drain. It is inbetween the square peice that goes to the frame.

i looked for it but i didnt realise it wasnt connected to the oil tank. hahah. thanks bro. good tip for me next time

I was about to say...if you have the GYTR skid, you cant get to it. They didnt cut out a drain hole for the front tank.
LAME!

ive got the ac skid and dont see the hole either hahahaha. hmm. i was thinking i could manuever a wrench in there but i dont think ill go therw the trouble. last time i just tilted her and it took all of 1 minute to do... i think ill just stick to my rigged ways aha.

how can u not see that...?..thats like not nowing where to put the gas on

get off my nuts.

so is the end cap or the raptor 700 06 soppost to come off?

haha.. thats just hilarious.

na im serios...because if its sopost to come out then mines is melted on their or something

Just a quick note, I added the oil filters for the raptor 700 to my oil filter special......check my website for details.

Paul